TOPIC: power trim

power trim 15 years 4 months ago #9965

dave bernard Offline Platinum Boarder Posts: 1471 Karma: 95 Thank you received: 30	if needed i have a working power tilt and trim pump with 4 hoses and 2 pistons.taking reasonable offers. 1 914 310 7086. Check this box to be notified of replies to this topic. Note: BBcode and smileys are still usable.
	Please Log in or Create an account to join the conversation.

Re:power trim 15 years 4 months ago #9971

onekawboy Offline Fresh Boarder Posts: 19 Thank you received: 0	what reasonable...i just picked a unit up wanting to know if i did good or drove 4 hrs for nothing...it does work... Check this box to be notified of replies to this topic. Note: BBcode and smileys are still usable.
	Please Log in or Create an account to join the conversation.

Re:power trim 15 years 4 months ago #9991

peterstransky
Offline
Expert Boarder
Posts: 353
Karma: 11
Thank you received: 0

will it fit a 1963 1000 long shaft? If so, shoot me a note at This email address is being protected from spambots. You need JavaScript enabled to view it. with what you are looking for for it.

I have a working PTT for the earlier eighties 6 cyc's that I was going to set up for my '63, but am running low on enthusiasm to figure out the conversion requirements.

Please Log in or Create an account to join the conversation.

Re:power trim 15 years 4 months ago #10042

Dr_Frankenmerc Offline Contributing Member Posts: 1433 Karma: 185 Thank you received: 44	Peter, I might be interested in your '80s trim unit if you decide to abandon that idea, and 'YES' Dave's system would be a slam-dunk to install on the early 1000. Thom Check this box to be notified of replies to this topic. Note: BBcode and smileys are still usable.
	Please Log in or Create an account to join the conversation.