TOPIC: 1962 lower unit drain

I have a 1962 70 HP white mercury with full shift. The oil drain holes in the lower unit are not low enough to drain. Short of pull the leg off is there a way to drain or pump the oil and potential water out of the the lower unit gear case?

tilt the motor up as far as possible lower trailer tounge put on a hill . pump it through till it comes clean. or drill and tap as a newer unit.

Dave,
Thank you for the reply. That is what I did last year and it seemed to work. I was just hoping that there was a pump that screwed into one of the holes..wishful thinking.

Thanks again.

make e fitting take a 3//8 coarse thread bolt and drill it in the center and adapt to a hose to your pump aluminum bolt is easier to work with.