TOPIC: Identification and impeller question 58a

Identification and impeller question 58a 9 years 4 months ago #120181

Dave the Wave Topic Author Offline Contributing Member Posts: 493 Karma: 21 Thank you received: 0	Is my 58a a 40 horsepower? Looking for an impeller the serial number matches the 40 hp. Where do I find the seal that goes in impeller screw on cover? Is there any gasket or sealer between the bottom chunk and center chunk? Only steps away from maiden voyage! Check this box to be notified of replies to this topic. Note: BBcode and smileys are still usable.
	Please Log in or Create an account to join the conversation. Florida's Amphicar restoration destination

Re:Identification and impeller question 58a 9 years 4 months ago #120188

Ferguson_Poole Offline Expert Boarder Posts: 268 Karma: 74 Thank you received: 12	Hi Dave, I sent you a private message in hopes of well answering your questions. Regards, Joe www.fergusonpoolemarine.com This email address is being protected from spambots. You need JavaScript enabled to view it. Check this box to be notified of replies to this topic. Note: BBcode and smileys are still usable.
	Please Log in or Create an account to join the conversation. Profile Picture: E. Carl Kiekhaefer (Mercury Founder) & Joe Poole Sr. @ 1964 Mercury Dealer Meeting

Re:Identification and impeller question 58a 9 years 4 months ago #120206

Dave the Wave Topic Author Offline Contributing Member Posts: 493 Karma: 21 Thank you received: 0	Joe emailed you back. But just in case. Ser # 1241826. Please include all seals and impeller adding seals behind prop. The housing looks very good. Thanks Dave Does anything go between lower unit where it meets center section? Attachments: Check this box to be notified of replies to this topic. Note: BBcode and smileys are still usable.
	Please Log in or Create an account to join the conversation. Florida's Amphicar restoration destination

Re:Identification and impeller question 58a 9 years 4 months ago #120207

Dave the Wave Topic Author Offline Contributing Member Posts: 493 Karma: 21 Thank you received: 0	I jumped the gun. Thank You for lengthy email. Best to do it right! Check this box to be notified of replies to this topic. Note: BBcode and smileys are still usable.
	Please Log in or Create an account to join the conversation. Florida's Amphicar restoration destination

Re:Identification and impeller question 58a 9 years 4 months ago #120213

Ferguson_Poole
Offline
Expert Boarder
Posts: 268
Karma: 74
Thank you received: 12

Hi Dave,
Thank you, I did e-mail you back. No, the gear housing mates metal to metal with the drive shaft housing (no gasket or sealant), if that is your question.

Regards,
Joe
www.fergusonpoolemarine.com
This email address is being protected from spambots. You need JavaScript enabled to view it.