Welcome, Guest
Username: Password: Remember me
  • Page:
  • 1

TOPIC: Starting the 'Fat 50' off the boat...

Starting the 'Fat 50' off the boat... 13 years 2 months ago #23385

  • Andgott
  • Andgott's Avatar Topic Author
  • Offline
  • Contributing Member
  • Contributing Member
  • Posts: 1243
  • Karma: 72
  • Thank you received: 0
I've got the new head gasket installed, and the compression is good on all 4 cylinders now. I cleaned up the carbs, and I'm going to replace the dry rotten fuel lines on the motor today.

Next, I want to see if it'll fire up, before deciding if it's worth putting any more time/money into this motor.

Do I have to hook up the wiring harness to do so?? Or can I use the pull start without it? I haven't gone through the wiring since I removed it from the boat, some of it may need to be replaced- I don't mind redoing it, but I'd like to make sure that the motor is going to run before doing so... Can I run it without the electrical 'stuff' hooked up? Thanks.

-Andrew

Please Log in or Create an account to join the conversation.

Re: Starting the 'Fat 50' off the boat... 13 years 2 months ago #23386

Check for spark by removing the wire from the magneto and pulling it over with the recoil.
If there is a generator you need that ( harness ) hooked up to a battery.
If you have spark ( like a lightning storm ) / clean carburetor / timing marks all lined up / compression then it will run.

Please Log in or Create an account to join the conversation.

Re:Starting the 'Fat 50' off the boat... 13 years 2 months ago #23431

  • Andgott
  • Andgott's Avatar Topic Author
  • Offline
  • Contributing Member
  • Contributing Member
  • Posts: 1243
  • Karma: 72
  • Thank you received: 0
Without the wiring connected, will I still get a spark? The ignition switch circuit obviously won't be closed- so am I correct in assuming that there would be no spark without it closed?

I'm getting close to where I want to try firing her up- Looks like the weather might cooperate for wheeling it out tomorrow and getting some cooling water to it, I just want to make sure I do it right :)

-Andrew

Please Log in or Create an account to join the conversation.

Re:Starting the 'Fat 50' off the boat... 13 years 2 months ago #23693

A magneto ignition circuit should be
" open "----to run and shorted out to
" stop "

Please Log in or Create an account to join the conversation.

  • Page:
  • 1
Time to create page: 0.168 seconds

Donate

Please consider supporting our efforts.

FG Login

Glassified Ads

1975 16ft Cobalt
( / Boats)

1975 16ft Cobalt
03-27-2024

Homelie/Bearcat
( / Engines)

noimage
03-17-2024

Thunderbird Apache 1956 hardtop
( / Boats)

noimage
03-10-2024

FiberGoogle

Who's Online

We have 7876 guests and 2 members online